Assembly & Set-Up - Troy-Bilt Flurry 1400 Manual Del Operador

Assembly & Set-Up
Contents of Carton
• One Electric Snow Thrower
• One Chute Assembly
NOTE: All references to the left and right side of the snow
thrower are from the operator's position behind the snow
thrower.
Tools Required for Assembly
• Phillips Head Screwdriver
Unpacking the Unit
1. Cut the corners of the carton and lay the sides flat on the
ground. Remove all packing inserts.
2. Lift the upper handle and mid handle up and off the snow
thrower. See Figure 3-1.
Figure 3-1
3. Make certain the carton has been completely emptied
before discarding it.
• One Upper Handle
• One Electric Snow Thrower
Operator's Manual
Handle Assembly
1. Install the strain reliever on the mid handle. See Figure 3-2.
NOTE: The flared area on the lower portion of the mid
handle must face forward throughout the assembly.
• One Mid Handle
• One Product Registration Card
Figure 3-2
3
7