Sangean U4 Instrucciones De Manejo página 31

USB socket for iPhone or Smartphone charging
Your radio has a USB socket which is intended only for charging an
iPhone or smart phone and similar devices. Charge time may vary
and in some cases may take longer to charge than when using the
manufacturers charging unit supplied with the smart phone.
. Ensure your radio is switched off .
2. Connect your smart phone to the USB charging socket at the
left side of your radio.
3. Your iPhone or smart phone will begin to charge.
4. Once your iPhone or smart phone has charged remove the
USB lead.
Note: Do not use USB charging if you want to charge the battery,
as the radio will fully charge the iPhone/Smartphone before you
can charge the battery.
Important:
• The charger may not supply power to some USB devices.
• When not using or after charging, remove the USB cable and
close the cover.
• Do not connect power source to USB port. Otherwise there is
risk of fire. The USB port is only intended for charging lower
voltage device. Always place the cover onto the USB port when
not charging the lower voltage device.
• Do not insert a nail, wire, etc. into USB power supply port. Oth-
erwise a circuit short may cause smoke and fire.
• Do not connect this USB socket with your PC USB port, as it is
highly possible that it may cause breakdown of the units.
• Never use the USB socket in rainy or moist conditions to pre-
vent moist from entering the radio. Always keep the rubber cov-
er on the back well closed under these conditions.
GB
30