Installation Of The Toilet - Artecristal AUSTRAL Manual De Instrucciones

INSTALLATION OF THE TOILET

INSTALLATION OF THE CISTERN
1. Insert the unloading mechanism over
the main hole of the tank, screwing it in
the bottom part with the following order:
washer, screw and rubber.
2. Next, place the discharge device,
screwing its respective washer and threa-
ded piece in the lower part. If you want to
adjust the cistern flow or water pressure,
simply move up or down the discharge
mechanism indicators.
3. Mount and install the feed mechanism
at the correct height. Please, check for
any leaks after installation. Once the nut
is tightened, the installation hole of the
ceramic can become distorted and could
cause leakage.
For a correct installation of this mecha-
nism, the critical filling level should be at
least 25 mm above the overflow valve.
4. Finally install the fixing kit of the tank
and adjust it with its respective washers
and nuts once the cistern is placed on the
seat.
1.
2.
3.
4.
ENG