SATA 97813 Manual Del Uso página 18

Safety valve screw （cannot be opened
and adjusted by itself）
Oil filler screw（not shown）
III. Installation and operation:
Handle installation:
1）Tighten the screws to connect and install the upper and lower handles.
2）Release the positioning screw on the handle and insert the handle into the handle hole.
3）Tighten the positioning screw to complete handle installation.
Exhaust:
1 ）Release the oil filler screw but do not remove it（see Figure 2）.
2）Insert the handle into the handle hole（see Figure 1）.
3）Rotate the handle counterclockwise（see Figure 1）and turn on the oil return valve.
4）Rotate the handle clockwise, lift and press it, and repeat this operation several times quickly to discharge air from the oil circuit.
5）Tighten the oil filler screw（see Figure 2）.
Oil filling:
1 ）Remove the oil filler screw （see Figure 2）.
2）Align with the oil filler and slowly add qualified hydraulic oil（see Figure 2） until it is 0.6 cm from the oil filler（note: do not press
the operating handle when adding oil）.
3）Replace the oil filler screw and tighten it.
Jacking:
1） Park the vehicle on a firm and level surface, and stop the engine.
2）Rotate the handle clockwise and lower the jack. After the lifting arm reaches the lowest level, rotate the handle clockwise and close
18
97813/97817/97818
中文
Universal Joint
Hydraulic pump
Figure 2
EN DE RU KO PT JA ES