LATICRETE STRATA_HEAT Guia De Funcionamiento página 14

Mounting Thermostat
1. Push excess wire back through the wall box and insert thermostat
back module into wall box.
2. Put fixing screws through mounting holes and tighten.
3. Ensure that thermostat is straight before tightening completely.
4. Replace thermostat front housing;
i) align and sit front housing on to hinges,
ii) push lower half of front housing until a 'click' is heard.
5. Ensure front housing is securely fixed.
6. IMPORTANT: Tighten both retaining screws
14
Do not use where exposed to water
Ne pas installer à proximité d'une source d'eau
L1-LOAD-L2
thermostat
L2
L1 LINE
1 2 3
EXT
SENSOR
(NO POLARITY)
Powering Up
You can now power up the thermostat and begin the programming process.
An easy to follow menu will guide you through the rest. If you want to turn
on / off the thermostat and heating system then hold down the recessed
button on the bottom of the stat for 3 seconds
Error Messages
Your thermostat can give you two error indications:
1. "er1": This will occur if no floor sensor is detected
2. "er2": This will occur if the floor sensor has a short circuit