Electrical Specification - LATICRETE STRATA_HEAT Guia De Funcionamiento

Introduction
The STRATA_HEAT Programmable Thermostat is designed to aid in the comfort of your home by providing timed regulation of your heating system. The thermostat
™
is designed to receive temperature input signals from the following sensors:
1. Air sensor located inside thermostat
2. Floor sensor installed in floor if using underfloor heating (See STRATA_HEAT Wire Installation Manual for details.)
3. Optional 2nd sensor
The thermostat is not a safety device. In order to avoid damaging your system the correct system and floor type should be selected during the thermostat programming process.

Electrical Specification:

Supply voltage: 110V-240V +/-15% at 60Hz
n
Thermostat is not designed for use with intermittent power supply.
n
Maximum Switch Load: 15A resistive
n
Insulation Class: II
n
Housing: Electrical Code Requirements
n
Standards: EN60730-1 & EN60730-2-9 standards
n
WARNING – Important safety note
This product uses mains voltage electricity and work should only be carried out by a qualified electrician. You should always isolate the power supply before attempting to
install or repair the STRATA_HEAT™ Programmable Thermostat. The thermostat should not be put into operation unless you are certain that the entire heating installation
complies with current general safety requirements for electrical installations. Electrical installation to be in accordance with latest Electrical Code Requirements.
Location
The thermostat should be installed inside a single gang electrical wall box that is at least 1 1/4" (32 mm) deep. For optimal performance the thermostat should be located
in an area with good ventilation. It should not be beside a drafty window/door, in direct sunlight or above another heat generating device (e.g. radiator or TV).
The thermostat is designed for operation between 32 - 131°F (0 - 55°C) with relative humidity less than 80%.
15