Portable Wirecam Control; Using The Remote; Manual Mode; Auto Mode - Noxon High Speed Cablecam Manual De Usuario

High-Speed Cablecam Control
English

Using the remote:

1. To scroll through the menu, turn the control knob.
2. Short press on the control wheel: select / enter / activate / execute.
3. Long press on the control wheel: perform exit / return / end / power off action.
Manual mode: Allows you to control the movement in real time.
• Turning the knob will cause a speed increase or decrease in one of the two directions of rotation.
• One press of the knob will cause direct passage to speed 0.
NOTE: A loss of connection between the control and the appliance will also cause a safety braking.
Auto mode: Allows you to program a tour and play it whenever you want with different acceleration
and speed parameters.
Single-section automatic movement
• Press the knob by positioning the cursor on the scroll line.
• By moving the control wheel it is possible to move the axis and by clicking to establish the initial
position of the movement.
• A quick double press will go back in the recording sequence, allowing you to change previously set
points.
• Once all the necessary points have been established, keeping the knob pressed will finish the pro-
gramming and the device will take the axis to the initial point that has been established.
• After the points have been recorded, the speed (SPEED1) and acceleration (RAMP) parameters
can be set.
SPEED1: Defines the speed on a scale from 1 to 40. It is possible that the system limits the speed
selection due to the fact that the available distance is not enough to reach the highest speeds.
RAMP: Defines the percentage of travel that will be used to accelerate and decelerate. Accelerations
will always have a symmetrical profile, that is, the same distance will be reserved for accelerating as
for braking.
REPEAT: We can choose between a repetitive movement that reproduces the programmed section
successively forward and backward. One press of the knob will stop the movement and return the
appliance to the initial position.
GO: A press with the cursor on GO launches the movement start sequence.
Pág. 15