Filling The Water Tank - McCulloch MC1255 Guia Del Usuario

FILLING THE WATER TANK

• Unplug power cord from electrical outlet.
1. Remove the fill cap.
2. Using the funnel, fill the water tank. Replace the
fill cap when filled to desired level (10 oz.).
NOTE: In order to get maximum steam time,
make sure the water tank is filled completely.
Make sure the unit is standing upright as shown.
USING THE STEAM TRIGGER
NOTE: After plugging in the power cord, allow
the unit to heat. After approximately 30 sec-
onds, you are ready to begin steaming.
1. Hold down the Steam Trigger to bring steam to
the Steam Outlet and out of the selected accessory.
NOTE: When pressing the Steam Trigger, it will
take a few seconds for the steamer to produce
steam. Likewise, the steamer will produce
steam for a few seconds after releasing the
Steam Trigger.
USING THE STEAM LEVEL SWITCH
1. You can control the amount of steam emitted by
using the Steam Level Switch.
• Slide the switch toward High (+) in order to
increase the flow of steam.
• Slide the switch toward Low (-) in order to
decrease the flow of steam.
ENGLISH | 7