General Operation - McCulloch MC1255 Guia Del Usuario

GENERAL OPERATION

NOTE: Be sure Steam Outlet is free of any debris and any desired accessories are con-
nected before following these steps. If Steam Outlet shows any debris please refer to
Mineral Build-Up on page 10.
1. Plug grounded power cord into a convenient electrical outlet (make sure to first remove plastic
cover that protects plugs during shipping). Power Light will immediately illuminate.
CAUTION: This unit uses a grounded (3-prong) electrical plug. Use only in properly
installed 3-prong electrical outlets. Do not attempt to alter plug or circumvent this safety
feature in any way.
NOTE: Power Light is illuminated at all times while unit is plugged in. This unit has no On/
Off power switch; it will begin heating immediately upon being plugged in.
2. Allow unit approximately 30 seconds to heat up.
3. Set Steam Level Switch to desired intensity of steam flow. Adjust between High (+) and
Low (-) steam settings to control the intensity of steam for the task at hand.
4. Direct towards surface you desire to steam, and press Steam Trigger.
NOTE: Pressing the Steam Trigger activates the unit's pump. It will take a few seconds to
actually begin producing steam. The unit will continue to produce steam for another few
seconds after Steam Trigger is released.
5. To sanitize surfaces, press Steam Trigger and hold approximately 1/2 inch from surface for at
least 5 seconds (this will maximize the effectiveness of the steam cleaning).
CAUTION: Always be sure the Handheld Power Steamer and any accessories are pointed
in a safe direction (away from yourself, other people, pets, and plants) before pressing
Steam Trigger.
6. Keep Steam Trigger depressed for a continuous flow of steam. Using a slight back-and-forth
motion over the area you are steaming to further enhance the cleaning process.
7. Hold down the Steam Trigger as needed for sufficient steam supply. Use the Nylon Utility
Brush accessory to brush away dirt, grease, unwanted dried paint, etc. DO NOT
over-scrub the surface unless you are cleaning tiles or stone.
8. Use only clean tap water or distilled water (recommended) when using the steamer. No
detergents or any other additives are needed.
9. At the end of use, immediately unplug grounded power cord from electrical outlet. Follow
steps under Proper Storage procedure on page 10 of this manual.
8 | ENGLISH
Using Your Handheld
Power Steamer