Vicks V5100NS Manual De Uso Y Cuidado página 3

Carrying
Handle
Water Tank
Tank Cap
Demineralization
Cartridge (included
in certain models)
Scent Pad Slot
Mist
Intensity
Indicator
Scent Pad
Heater Vent
Power Knob
4
Using Your Vicks UltraQuiet Cool Mist Humidifier
First Time Use
Directional
Mist Nozzle
Read all instructions before using this appliance.
Unpack and remove all packing material from the Water Tank, Mist Nozzle and Base.
Completely unravel power cord and place unit on a flat, stable surface. Remove the
protective wrapper from the Demineralization Cartridge and place into the unit as shown.
Follow the directions below to fill and operate the humidifier.
Filling the Water Tank
Always UNPLUG the humidifier before filling.
1.
2.
3.
4.
Water Valve
Reservoir
Air Outlet
Water
Sensor
Ultrasonic
Nebulizer
Base
Remove the Water Tank from the Base and turn it upside down. Turn the Tank Cap
counterclockwise to open. Rinse and wipe clean.
Fill the Water Tank with clean, cool, tap water and replace the Tank Cap by firmly
turning clockwise. Turn the Tank upright and check Tank Cap for leaks. If any water
drips from Tank Cap, remove it and re-tighten. Use of very cold water may
temporarily reduce the mist output. Never fill the humidifier with hot or
warm water as this could cause damage and void your warranty.
To avoid white dust we recommend using a Protec Demineralization Cartridge (Model
PDC-51) and replacing it after 30-40 fillings. If you live in an extremely hard water
area you may also wish to use distilled water to further reduce white dust. Refer to
About White Dust section.
Inspect the Base and Nebulizer for cleanliness. Refer to Care and Cleaning section.
Replace the Water Tank on the Base.
5