Braun SmartControl 199s-1 Manual De Instrucciones página 6

Our products are designed to meet the highest standards of quality,
functionality and design. We hope you entirely enjoy your new Braun product.
This appliance is designed for household use only.
Description
1a Foil protection cap
1b Shaver foil
2 Cutter block
3 Foil release button
4 On/off switch
5 Long hair trimmer
6 Charging light (green)
7 Low charge light (red) (only model 199s)
8 Special cord set
Charging
• Recommended ambient temperature for charging is 41 °F to 95 ° F / 5 °C
to 35 °C. The battery may not charge properly or at all under extreme low
or high temperatures. Recommended ambient temperature for shaving is
60 °F to 95 °F / 15 °C to 35 °C. Do not expose the shaver to temperatures
higher than 122 °F / 50 °C for extended periods of time.
• Using the special cord set, connect the shaver to an electrical outlet with
the motor switched off.
• When charging for the first time or when the appliance is not used for a
few months, leave the appliance to charge continuously for 4 hours.
• The charging light shows that the appliance is being charged. When the
battery is fully charged, the charging light turns off. Intermittent blinking
after a while indicates that the battery maintains its full capacity. This can
also happen short term when charging after the battery was completely
discharged.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• A full charge provides up to 40 minutes of cordless shaving time
depending on your beard growth. However, the maximum battery capacity
will only be reached after several charging/discharging cycles.
• The red low-charge light (7) (only model 199s) flashes when the battery is
running low. You should be able to finish your shave.
6