Chapter Ii Product Illustration - SATA 97813A Manual Del Uso

3 ） Select a jack of appropriate deadweight tonnage based on the weight of the vehicle.
4 ） Overloading of the jack is prohibited, otherwise the liability for accidents will not be covered by insurance.
5 ） Unbalanced loading is prohibited and it is not allowed to lift the vehicle in a tilting manner, otherwise it will be dangerous and the
jack and the vehicle may be damaged.
6 ） Brake the vehicle and shut off the engine before operation.
7 ） Confirm that the support surface is hard and level before operation, otherwise there may be danger.
8 ） The jack can only be used for jacking and cannot be used for supporting, and a matching jack support must be used to support the
vehicle immediately after jacking.
9 ） The jack tray must be carefully aligned with the support point on the vehicle chassis first, and the vehicle can be raised with the
jack.
10 ） The handle shall not be turned during the jacking, otherwise the oil return valve will be unscrewed, resulting in lowering of jack tray.
11 ） The vehicle shall not be moved during operation.
12 ） For lowering of the jack, the handle must be turned counterclockwise slowly to lower the vehicle slowly.
13 ） Do not work on, under or around the vehicle supported only with the jack.
14 ） Do not disassemble or refit the jack by yourself.
15 ） The safety valve cannot be adjusted by the user, otherwise the liability for accidents will not be covered by insurance.
16 ） The operator must wear goggles and working gloves conforming to relevant national safety regulations during operation.

Chapter II Product illustration

Rubber tray
Note: The oil pump of the product is filled with 15# mechanical oil at delivery. It is recommended to use 10# aircraft hydraulic oil if the
product is often used below 0℃ . During change, please discharge all the 15# mechanical oil out from the oil pump, and then add
the 10# aircraft hydraulic oil. For specific operation, please refer to page 4.
97813A
Handle
Dual hydraulic pump
Fig. 1
中文
EN
pump Universal joint
Safety valve screw（Do
not unscrew it for pressure
regulation by yourself）
Oil filler screw
Fig.2
DE RU KO PT JA
Hydraulic
ES
13