LUND 318094 Instrucciones De Instalación página 3

Installation Steps
4
Thread the 10mm Hex Bolt a few threads into and through the Lock Nut welded onto the back tab on the Front Bracket.
5
Insert the Support Plate with the welded socket facing down, into the space between the Front Bracket and the floor panel behind the
pinch weld. (Fig. 7). Tighten the Hex Bolt until the Plate is held in place by the end of the bolt but not touching the floor panel. Do not
6
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
Next, select (1) Support Plate and (1) 10mm x 50mm Hex Bolt. (See Fig. 5)
tighten hardware at this time.
Fig. 5
(Fig. 6)
Front
10mm x 50mm Hex Bolt
Fig. 6
Front
Support Plate
Fig. 7
Page 3 of 5
Front Bracket installation
pictured.