Installation Steps - LUND 318094 Instrucciones De Instalación

Installation Steps

Starting on the passenger side front of the vehicle, locate and remove the 2nd and 3rd round factory rubber plugs in the bottom of the
body panel located closest to the front tire opening, (Fig. 1). On the passenger side rear of the vehicle, locate and remove the last (2)
factory rubber plugs in the bottom of the body panel located closest to the rear tire opening, (Fig. 2).
Remove plugs
Passenger side front mounting location
pictured. Use the 2nd and 3rd mounting
1
hole from the front fender opening.
Select (4) Bolt Plates. Insert each Bolt Plate into the factory hole with long end of the plates facing each other. (Fig. 3).
2
Hold the Front Bracket over the bolt plates and line up the (2) mounting holes. (Fig. 4) Secure the bracket to the bolt
3
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
Front
Fig. 1
Do this for both front and rear locations.
Rear
plates with (2) 10mm Flange Nuts. Do not tighten hardware at this time.
Front
Remove plugs
Passenger side rear mounting location
Fig. 3
Offset
Fig. 4
Page 2 of 5
Front
Fig. 2
pictured
Dashed line represents long
end of plate on Bolt Plate. Rear
mounting location shown.
(Bottom of Passenger side front
mounting bracket pictured.
IMPORTANT: Note the offset
mounting tab toward rear