LUND 318094 Instrucciones De Instalación página 4

Installation Steps
7
Position the passenger's side running board onto bracket and center on vehicle. Slide the bolts (bolts are already installed on board)
forward or back to line up with the slots in the (2) previously installed Mounting Brackets. Hold the Running Board up to the vehicle at a
slight angle and gently push bolts into slots. Attach the Running Board to the Mounting Brackets with the included (4) 5/16" Flange Nuts.
8
Note that the mounting locations, (front and rear lower body panels), for the Brackets are slightly curved and not flat. Check to see
if the Running Board is level to the car, front to rear, not level to the ground. To adjust, loosen the 10mm Bracket hardware and slide
the Brackets up or down the lower body panel. Once level, tighten the 10mm Bolt Plate to Bracket hardware only. The Hex Bolt on the
back of the Mounting Bracket for the Support Plate should be completely loose at this time.
Next, check for level to the ground, side to side only. If the outside edge of the running board is tilted down, tighten the long 10mm
Hex Bolts on the back of the (2) Mounting Brackets evenly until the Running Board is level. If the Running Board is tilted up, loosen
the Hex Bolt in the Support Plate a little until the Running Board is level. If the Support Plate is loose and the Board is still not level,
loosen the Brackets completely and move them up or down on the body panel until the Board is properly adjusted.
Tighten all bracket hardware, position the board accordingly, and then tighten Running Board to brackets.
9
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
Repeat Steps 3-6 to install the passenger side Rear Bracket. (Fig. 8).
NOTE: For Rear Bracket installation, use 10mm x 40mm bolt in Step 4.
Passenger rear Bracket installation pictured
(Fig. 9). Do not tighten at this time.
Adjust Running Board to be parallel and centered with side of vehicle.
Repeat Steps 1 thru 9 for opposite side of vehicle.
Rear
(Fig. 8)
Front
Fig. 9
Page 4 of 5
Tilt the Running Board up and
push back into position against
rocker panel. Line up bolts with
Brackets