Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.0 Assemble Mold Body
6.1
Assemble end caps onto mold body. Center mold body
over splice with pour spouts in upright position.
Important: Cables and connector must be centered in mold.
7.0 Pour Splice
7.1
Position splice level. Mix resin thoroughly per
instructions on resin package. Pour resin immediately
after mixing. Fill mold through one spout until both
spouts are completely filled.
7.2
When resin has solidified and cooled, splice may be put
into service.
78-8124-4521-7-E
3
Publicidad
Tabla de contenido
