Sony SU-WL500 Instalación página 5

When using an electric screwdriver, set the torque
setting to approximately 2 N·m {20 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the TV cabinet.
2
Referring to the Screw and Hook
locations diagram/table on
page 9, determine the screw
positions, and secure the
Mounting Hook to the rear of the
TV.
 Secure the Mounting Hook to the rear of the
TV temporarily, using the four screws (+PSW6
× 25).
 Be sure that both screws are securely
tightened with equal torque strength to the
rear of the TV.
Screw
(+PSW6 × 25)
(not supplied)
Five spacers
(not supplied)
Mounting
Hook
10 mm
13
( / inch)
32
Make sure that the screw 
3
firmly secures the arm base of
the Mounting Hook (both left
and right).
Notes
• When installing in portrait orientation, be sure to
keep the Mounting Hook angle to 0 degrees. Do
not use another angles.
• Make sure that the two arm bases are screwed in
securely.
5
(GB)