BOHELL MF300 Manual Del Usuario página 16

If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
FITTING SAFETY DEVICES
- Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
- Take special care about the accessories. They
may be stored and used according to the manu-
facturer's instructions.
- Do not use the appliance if the accessories
or consumables attached to it are defective,
Replace them immediately.
FITTING THE ACCESSORIES
- If an accessory is assembled, loosen the screw
(I) using the Allemn wrench (K)
- Mount the accessory (F or G) on the tool holder
(E). The pins of the tool holder must engage in
the openings of the accessory.
- For a more confortable work you can mount the
accessories (F or G) in any snap-in position on
the tool holder.
- Fasten the accessory on the tool holder. Tighten
the screw and the nut on the tool holder with the
allen wrench.
- Check the accessory is securely and strongly
fastened.
FITTING THE SANDING PAD
- Mount the accessory on the tool holder. The
pins of the tool holder must engage in the open-
ings of the accessory.
- Fasten the accessory on the tool holder. Tighten
the screw and the nut on the tool holder with the
allen wrench.
- Check that sanding pad is securely fasten.
- WARNING: The holes on the used sand paper
need to fit the holes on the sanding pad for
a proper functionality of the dust collection
system.
INSTRUCTIONS FOR USE
BEFORE USE:
- Ensure that the voltage indicated on the rating
label matches the mains voltage before plug-
ging in the appliance.
USE:
- Prepare the appliance tto the function you want
to develop.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off switch
(A).
ELECTRONIC SPEED CONTROL:
- The speed of the appliance can be regulated
by using the speed regulator
function is very useful, as it makes it
adapt the speed of the appliance to the type of
work that needs to be done.
- CAUTION: If the appliance continuesly works at
low speed, working life of the appliance will be
severly reduced.
SAWIING
- Always check the workpiece before operation
and remove any obstructions such as nails,
staples, screws, strings, rags and other debris.
- Plunge cutting is only allowed in soft materials
such as wood or plastic boards.
- Apply light and uniform pressure to obtain a
suitable result.
SANDING
- Apply light and uniform pressure to obtain a
suitable result.
SCRAPING
- Select a high-speed rate.
- Apply light and uniform pressure to obtain a
suitable result.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance by releasing the on/off
switch.
- Unplug the appliance from the mains.
- Close the lid.
- Put on the protective cover.
- Remove the remaining staples or nails from the
magazine after using the appliance.
- Remove the battery from the appliance if you
are not intending to use the appliance during an
extended period.
- Clean the appliance.
MAINTENANCE AND CARE
- WARNING! Always unplug the machine before
carrying out work on it.
- Checking the saw blade: deposits of resin and
glue on the saw blade cause inefficient cutting.
To avoid them, always clean the blade immedi-
ately after use.
control (B). This
possible to