2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
WARNING:
tool or any part of it. Damage or personal injury
could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
Intended Use
This string trimmer is designed for professional trimming
applications. DO nOT use under wet conditions or in
presence of flammable liquids or gases.
This string trimmer is a professional appliance. DO nOT
let children come into contact with the tool. Supervision is
required when inexperienced operators use this appliance.
This is not an edger and is not intended to be used for edging.
ASSEMBLY AND ADJUSTMENTS
WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
WARNING:
Damage or personal injury could result.
WARNING:
WITHOUT GUARD FIRMLY IN PLACE. The guard
must always be properly attached on the appliance to
protect the user.
Assembling the Pole (FIG. A, C)
1. To assemble the pole, line up the hole (
trimmer pole (
) with the pin (
8
2. Pull the pin out and slide the lower trimmer pole into
the upper trimmer pole (
3. Release the pin and ensure it fully engages the hole.
4. Secure the poles by tightening the bracket wingnut (
fig. C
17
Never modify the power
To reduce the risk of
Never remove the guard.
NEVER OPERATE appliance
) in the lower
15
) on the pole bracket (
16
7
) as shown in figure C.
16
15
Adjusting the Auxiliary Handle (FIG. A, D)
If adjustment is necessary, loosen the handle bolts (
slide the auxiliary handle up or down the upper trimmer
pole (
7
) . Then, retighten the bolts (
18
) . Ensure the handle is securely attached.
fig. D
OPERATION
WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
WARNING:
protection that conforms to ANSI Z87.1 (CAN/CSA
Z94.3) while operating this appliance.
Installing and Removing the Battery Pack
(Fig. A, E, F)
nOTE: For best results, make sure your battery pack is
fully charged.
WARNING:
installing battery, make certain the lock-off lever is not
engaged to prevent trigger actuation.
To install battery pack: Insert battery pack (
housing (
12
) as shown in figure E until fully seated and an
audible click is heard.
Make sure battery pack is fully seated and fully latched into
position.
To remove battery pack: Depress the battery release
button (
14
) on the battery and pull battery pack out of
) .
9
appliance as shown in figure F.
fig. E
17
) .
19
) through the bracket (
19
19
18
To reduce the risk of
Always use proper eye
Before removing or
English
19
) and
13
) into battery
7