Remove Bumper Fascia - (A) Using Plastic Trim Tools, Loosen The Lower Part Of Wheel Well Trim By Unclipping The Tabs From Fascia And Gently Pulling It Outward Both Sides. (B) Using - Horizon Global 76199 Instrucciones De Instalación

3. Remove bumper fascia – (a) Using plastic trim tools,
(b)
loosen the lower part of wheel well trim by unclipping the
tabs from fascia and gently pulling it outward both sides (b)
Using T25 torxbit socket, remove (1) screw in the upper area
behind wheel well trim both sides. (c) Open lift gate. Using
T30 torxbit socket, remove (2) screws near trunk weather
seal.
(a)
(c)
©2018 Horizon Global™ Corp - Printed in Mexico Sheet 6 of 30 76199NP 05-01-18 Rev. A