Power Supply; Battery Management And Safety Procedures - AEB ANT B-TWIG 8 MOBILE Manual De Uso

3.2 | POWER SUPPLY

4
B-TWIG 8 MOBILE
8 User manual |
1 POWER ON/OFF/CHARGE
Three position switch
ON: Power on
OFF: Power off
CHARGE: Internal battery charging
2 FUSE
Protection fuse.
WARNING: Replace the fuse only with one of the same type and with
the same values. If the fuse continues to blow, contact an authorized
service center.
3 MAINS INPUT
IEC input socket with integrated mains filter. Insert the power cord, supplied with
the system, in this socket. Check that the unit is turned off before connecting
the cable to mains. For your safety, never disconnect the grounding pole.
4 COOLING FAN AND VENTILATION SLOTS
The cooling process of the amplifier and panel temperature maintenance
within the legal limits is guaranteed by proper device ventilation, therefore it
is recommended not to obstruct or cover in any way subwoofer rear frame
ventilation slot.

3.3 | BATTERY MANAGEMENT AND SAFETY PROCEDURES

1
The B-TWIG 8S MOBILE subwoofer incorporates a 28.8V - 5000 mAh li-ion
battery equipped with all protections complying with current safety regulations.
The internal battery offers the following features:
• Charge indicator integrated with the system: the internal electronic circuits
allow you to monitor the state of charge. The upper panel relevant indicators
will light up showing the state of charge as a percentage of the full battery
2
charge.
• Safety and reliability: the numerous integrated safety protections provide
protection for individual cells as well as for users.
• Quick charge: Lithium-ion batteries, not requiring a long-term compensating
charge, charge quickly to their maximum capacity.
3
• Partial recharges tolerance: since the li-ion cells tolerate partial recharges,
the suspension of the charge procedure and the use of the battery before full
charge, when required by the installation needs, have no impact on battery
life cycle.
The access compartment to the battery pack is at the bottom of the subwoofer.
To access the battery, remove the cover fixing screws (Fig.1)
B-TWIG 8 MOBILE
9
| User manual