Ryobi PBC-3046YB Manual De Utilización página 27

PBC-3046YB manual
GB
F D E
ASSEMBLY
GRASS DEFLECTOR (Fig. 6)
Attach the grass deflector (14) to the blade guard by
■
placing the three locking tabs (33) into the three
notches (31).
Snap the blade guard and grass deflector together to
■
lock into place.
WARNING
Always stop the engine and remove the spark
plug wire before making any adjustments such
as changing cutting heads; this is to reduce the
risk of serious personal injury.
CONVERTING FROM STRING TRIMMER TO
BRUSHCUTTER
REMOVING THE STRING HEAD (Fig. 7)
Align the slot in the upper flange washer (34) with the
■
hole in the gear head. Place the holding pin (35)
through the slot in the upper flange washer and the
hole in the gear head. Turn the spool retainer (37)
clockwise to remove. Remove the spool (50) and
string head (36) from the drive connector (38).
Remove the upper flange washer from the gear shaft
■
and retain for blade installation.
Remove the grass deflector by pushing in on the
■
three locking tabs while pulling on the grass deflector
to separate from the blade guard.
Note: Store the string head parts together for
■
later use.
INSTALLING THE BLADE (Fig. 8)
Place the upper flange washer over the gear shaft
■
with the hollow side toward the blade guard.
Center the blade on the upper flange, making sure
■
the blade(6) sits flat. Install the cupped washer (40)
with the raised center away from the blade. Install the
blade nut (41). The blade turns counterclockwise from
the operator's position.
Place the holding pin through the slot in the upper
■
flange washer and the hole in the gear head (7).
Using the 13 mm (1/2 in.) wrench (42) supplied, turn
the blade nut counterclockwise.
Tighten nut securely.
■
10/01/05 9:29 Page 20
I P NL S
English
DK N FIN GR H
CONVERTING FROM BRUSHCUTTER TO
STRING TRIMMER
REMOVING THE BLADE (Fig. 8)
Place the holding pin through the slot in the upper
■
flange washer and the gear head. Turn the blade nut
clockwise to remove.
Remove the cupped washer and the blade.
■
Remove the upper flange washer from the gear shaft
■
and retain for the string head installation.
Attach the grass deflector to the blade guard by
■
placing the three locking tabs into the three notches.
Snap the blade guard and grass deflector together to
■
lock into place.
Note: Store the brushcutter parts together for
later use.
INSTALLING THE STRING HEAD (Fig. 7)
Install the upper flange washer onto the gear shaft
■
with the hollow side toward the gear head.
Place the holding pin through the slot in the upper
■
flange washer and the hole in the gear head. Using
the 16 mm (5/8 in.) wrench supplied, turn the drive
connector counterclockwise to install. Tighten
securely.
Place the string head on the drive connector.
■
Place the holding pin through the slot in the upper
■
flange washer and the hole in the gear head.
Install the spool retainer and turn counterclockwise to
tighten securely.
OPERATION
Read the operation manual and follow all
warnings and safety instructions.
Wear eye protection and ear protection.
Keep all bystanders, especially children and pets,
at least 15m from the operating area.
FUEL AND REFUELING
HANDLING THE FUEL SAFELY
Always handle fuel with care, it is highly flammable.
■
Always refuel outdoors where there are no sparks
■
and flames. Do not inhale fuel vapors.
Do not let gasoline or oil come in contact with
■
your skin.
20
CZ RUS RO PL