Ryobi PBC-3046YB Manual De Utilización página 31

PBC-3046YB manual
GB
F D E
MAINTENANCE
Repeat above step with second string (58), using the
■
bottom part of spool. Do not overfill.
Replace the spool and the spool retainer. Refer to
■
"Spool Replacement " earlier in this manual.
BLADE PROTECTOR (Fig. 22)
Always place the blade protector (59) on the blade when the
unit is not in use. The blade protector has clips (60) around
the edges to snap over the blade and keep it in place.
Wear gloves and be cautious when handling the blade.
Note: Always remove the blade protector before using
the unit. If not removed, the blade protector could
become a thrown object as the blade begins to turn.
CLEANING THE EXHAUST PORT AND
MUFFLER
Depending on the type of fuel used, the type and amount
of oil used, and/or your operating conditions, the exhaust
port and muffler may become blocked with carbon
deposits. If you notice a power loss with your gas
powered tool, a qualified service technician will need to
remove these deposits to restore performance.
SPARK ARRESTOR
The spark arrestor must be cleaned or replaced every
25 hours or yearly to ensure proper performance of your
product. Spark arrestors may be in different locations
depending on the model purchased. Please contact your
nearest service dealer for the location of the spark
arrestor for your model.
Cleaning Instructions:
Remove the spark arrestor from the muffler.
■
If your spark arrestor is made of a fiberglass material,
■
discard and replace.
If your spark arrestor is made of a metal material
■
follow these cleaning instructions:
1. Spray the spark arrestor with a quality carbon
cleaner.
2. Gently clean using a wire brush.
3. Install the new or cleaned spark arrestor and
reassemble completely before use.
REPLACING AND CLEANING AIR FILTER
(Fig. 23 & 24)
For proper performance and long life, keep air filter clean.
10/01/05 9:29 Page 24
I P NL S
English
DK N FIN GR H
1. Remove the air filter cover by pushing down on the
latch (61) with your thumb while gently pulling on the
cover (65).
2. Remove the filter (62), clean it in warm soapy water.
Rinse and let dry completely. For best performance,
replace annually.
3. Reinstall the filter.
4. Replace the air filter cover by inserting the tabs on the
bottom of the cover (64) into the slots on the air filter
base (63); push the cover up until it latches securely
in place.
FUEL CAP
WARNING
A leaking fuel cap is a fire hazard and must be
replaced immediately.
The fuel cap contains a non-serviceable filter and a
check valve. A clogged fuel filter will cause poor engine
performance. If performance improves when the fuel cap
is loosened, check valve may be faulty or filter clogged.
Replace fuel cap if required.
SPARK PLUG
This engine uses a Champion RCJ-6Y and NGK BPMR
7A with 0,63mm (.025 in.) electrode gap. Use an exact
STORAGE (1 MONTH OR LONGER)
Drain all fuel from tank into a container approved
■
for gasoline. Run engine until it stops.
Clean all foreign material from the trimmer. Store it in
■
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Cover the blade with the blade protector before
■
storing the unit, or during transportation.
Abide by all ISO and local regulations for the safe
■
storage and handling of gasoline. Excess fuel should
be used up in other 2-stroke engine powered
equipment.
24
CZ RUS RO PL