Publicidad
Idiomas disponibles
Idiomas disponibles
• Scanner Receiver
• Antenna
• Belt Clip
Battery installation is made more convenient when the belt clip is removed. To do this,
release the spring clip securing the belt clip to radio and slide the belt clip downward
and away from the radio body. Next, press down with the thumb at the arrow, slide the
battery cover down and lift off the battery cover. Insert four AAA batteries (alternate
positive ends (+) toward the bottom of the transceiver (starting right to left).
SPRING CLIP
BELT CLIP
BATTERY COVER
1. Using thumb, press down on battery cover at arrow and slide cover down to open.
. Slide the cover down and then lift cover at bottom to open. Remove cover.
3. Insert four AAA batteries (positive(+) end toward the bottom beginning at right side
and alternating positive terminals as shown).
NOTE:
Alkaline batteries (recommended) will give you approximately 7 hours constant re-
ceive.
If rechargeable batteries are used these will give you up to 3 hours use, so spare sets
of recharged batteries should be available.
TSC-100R/100RBT
• Antenna Adaptor(SMA to BNC)
INSTALLING THE BATTERIES
INSTRUCTION MANUAL
SUPPLIED EQUIPMENT
NEGATIVE
TERMINALS
POSITIVE
TERMINALS
5
Publicidad
Capítulos
