D+H LAH 65-BSY+ Manual Original página 9

Reference Run (Zeroing) – single drive*
Special magnet
MAG 502
99.826.56 1.2/04/16
1. Close drive. Possibly the drive opens and closes
three times (closing edge protection) and then
remains in the last position.
2. Wait until the drive has driven completely closed.
3. Voltage must continue to be applied to the drive
when moving in the "CLOSE" direction.
4. Hold the magnet next to the drive as shown in
the illustration.
5. The magnet gives the drive a second CLOSE
command and performs zeroing in the event of
an overload cut-off.
6. This is confirmed by the drive quietly humming.
7. Each drive of the set must be individually zeroed
in a synchronous group.
* Drive group: Software SCS is required.
English
9/20
LAH 65-BSY+