ZUMEX Speed Pro Manual De Usuario página 28

Self Service Tap Up (44U), Self Service Tap S
Assembly of the Up Tap (13.1)
Hold the centring device/bottle holder with one hand while turning the nut on the holder with
the other hand to secure it to the spout on the container.
Align the tap with the centring device/bottle holder and insert the button between the arms
of the holder. Hold the tap with one hand while turning the tap fixing nut with the other hand.
Disassembly of the Up Tap (13.1)
Hold the tap with one hand while loosening the tap fixing nut with the other hand. After
loosening the tap fixing nut, gently pull the tap out.
Hold the bottle holder with one hand while unscrewing the centring device/bottle holder nut
with the other hand. Pull gently to separate it from the thread of the container.
! Important! Use both hands to dismantle the tap and holder to avoid any parts being dropped
or injury.
Assembly of the S+ Tap (14.1+)
To install the S+plus tap in the container, hold the tap with both hands, line up the pin with
the hole in the container thread and gently push the tap in. Hold the tap firmly by the bottle
holder with one hand and tighten the tap floating fixing nut with the other hand.
Note: Remember to tighten the floating nut until the threads on the container are no longer
visible.
If it is not positioned correctly, the tap sensor will not be activated.
Disassembly of the S+ Tap (14.1+)
Hold the tap with one hand while loosening the tap fixing nut with the other hand.
After loosening the tap fixing nut, gently pull the tap out.
!
Important! Handle the tap with both hands, do not force the pin or the tap thread. Do not
put any weight on the tap.
Tap operation (Fig. 13.2 and 14.2+)
The tap is operated by pressing and releasing for juice extraction.
On the SS S +plus tap (44+), the button is located on the outside. The button can be locked
in the "free spout" position. To do this, turn the ring with the dotted/continuous lines until
the continuous line is over the glass icon. Release the button. It is now locked in position. To
release, simply press the button again.
(44+)
+plus
The Speed S +plus All-in-One machine has a bottle holder that can be removed, if necessary,
by removing the two rear screws.
On the SS Up tap (44U), the button is located on the inside. The button can be locked in the
"free spout" position. To do this, press the button completely and move the metal tab on the
side of the bottle holder/centring device. Release the button. It is now locked in position. To
release, simply press the button again.
For the daily cleaning of both taps you must remove the upper part as shown in the
images (Fig. 13.2 y 14.2+). The Up tap is dismantled by turning the plastic ring on the tap
body and then removing the button. The S +plus tap is dismantled by turning the ring on
the metal body.
Detector tube gasket (46)
If required, this gasket can be removed for cleaning (Fig. 3U or 4).
Machine supplement (47)
Use this supplement to raise the machine (Fig. 3U or 3+).
Important! Never place the machine onto the supplement alone, it should always be done by
!
at least two people.
Tank Juice Container (50)
Line up the two side lugs at the ends of the container and press. Pressing the side buttons may
help mount it (Fig. 15).
To remove the container, just press the side buttons and pull out towards you.
Tank Sub-filter (51)
Place on the inside of the juice extraction container (Fig. 5+).
EN
53