Operation - Chal-tec 10032236 Manual De Usuario

EN
16
Replace the pads
1 Use the original cleaning or waxing pads (see mark on the back of the pad).
2 Put the adhesive side of the pad on the totary plate (see picture 1).
3 Power off and hold the edge of the pad and then slightly pull off the pad.

OPERATION

1 Choose the right pads before use
2 Select the mopping mode when mop the floor. Hold the handle and lean it slightly
3 backward, then drag it slowly back and forth. Push the spray button in need.
4 Clean the floor before waxing it, set the waxing pads and fill the tank with waxing
oil. Push the spray button when need.
5 Users can spray liquid wax by other sprayer and wax the floor with product.
6 Dilute the detergent and mop evenly on the floor. Clean the floor with clean water
at last.
Important Notes
• Don't mix water with liquid wax or waxing oil.
• The original waxing oil has no chemical smell and is environment-friendly.
• Empty the tank if not use for a long extended time
• Water lack protecting circuit will work when water pump idles for 3 seconds
• Please don't use the machine when charging it (Charging protection system will cut
off the power)
• The machine will stop working at the occurrence of over-current. Please restart the
machine if needed.