Schlage BE365 Instrucciones De Instalación página 3

5
Install baseplate.
Slides through same hole as wire.
Holds keypad and baseplate together
during installation.
CAUTION
Cam MUST be vertical!
Review Step 1!
6
Connect wire and 9V battery.
7
Place battery in holder and tuck wires.
Any wire routing is acceptable as long
as wires will not be pinched by cover.
8
Install cover.
Actual Size
Lock will beep when
battery is connected.
Actual Size
9
Install reinforcement plate and strike into door jamb.
For maximum
security, install
reinforcement
plate.
Strike Cut-Out (not to scale)
1¹⁄₂" (38 mm)
1" (25 mm)
Deep
¹⁄₈" (3 mm)
Pilot Hole
Test Lock
a
Lock (extend bolt).
1. Press the
Schlage button.
2. Rotate thumbturn
towards door edge.
Did bolt extend?
Yes. Lock is
installed correctly.
For troubleshooting information, go to schlage.com/faqs-keypad.
Door Stop
Actual Size
Actual Size
1"
(25 mm)
Rotate 180˚ if
door stop is on
left side.
2³⁄₄"
(70 mm)
¹⁄₈" (3 mm)
3" (76 mm) Deep
1¹⁄₈"
(29 mm)
No. Lock is not installed
correctly. Remove lock and
reinstall. Pay close attention
to cam position in step 1.