Rupes LE21A Instrucciones De Uso Y Manutención página 9

SAFETY WARNINGS APPLICABLE TO POLISHING OPERATIONS
If the use of an electrical tool in a damp area cannot be avoided,
use a power supply fitted with a differential switch (RCD).
This type of switch reduces the risk of electrical shocks.
PARTS OF THE TOOL
1 - Identification plate
2 - ON/OFF switch
3 - Electronic rpm regulation (LE21AEC - LS21AE)
4 - Base plate
5 - Velcroed drilled rubber plate
6 - Paper clamping lever (LE21AC-LE21AEC)
7 - Motor ventilation slots
8 - 29 mm Ø suction port
9 - Dust bag
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been
damaged during storage or transport;
- the tool is complete; check that the number and type of
components comply with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in
the table and that indicated on the tool identification plate
reproduced and explained on page 11.
ASSEMBLING THE TOOL
Fit the dust bag (9).
INSERTING THE ABRASIVE PAPER
LE21AC - LE21AEC
- Lift the paper clamping lever (6) by pressing the lever release;
- insert the abrasive paper under the lever until it rests against the
stop, then release the lever;
- repeat this operation on the opposite side of the plate, keeping the
paper taut and checking that the edges are parallel with the edges
of the plate before releasing the lever.
LE21A - LS21A - LS21AE
- Press the velcro backed abrasive paper in position, ensuring that
the holes in the paper coincide with the suction holes in the rubber
plate;
- make sure that there is no dust or other matter on the drilled rubber
plate.
BEFORE STARTING THE TOOL
Ensure that:
- the power supply conforms with the characteristics of the tool;
- the power supply cable and plug are in perfect condition;
- the ON/OFF switch works properly though with the power supply di-
sconnected;
- all the parts of the tool have been assembled in the proper manner
and that there are no signs of damage;
- the ventilation slots are not obstructed (7);
- the dust bag is enipty and not torn.
STARTING AND STOPPING
- Starting: press the switch (2) down in position "I".
- Stopping: press the switch (2) up in position "O".
TEST RUN
Start the tool and check that there are no unusual vibrations and that
the paper is kept taut.
Otherwise, switch-off the tool immediately and eliminate the cause.
REPLACING ABRASIVE PAPER
LE21AC - LE21AEC
- Lift the paper clamping lever (6) by pressing the release device and
remove the used paper;
- insert the new abrasive paper following the instructions in the
chapter on "INSERTING THE ABRASIVE PAPER".
LE21A - LS21A - LS21AE
- Rip off the used paper;
- press the new velcro backed paper in position, ensuring that the ho-
les in the paper coincide with the suction holes in the plate.
9