Yakima Raptor Manual Del Usuario página 2

Wheel Tray/Hoop Assembly
ATTACH WHEEL TRAY TO
HOOP ASSEMBLY.
• Insert short bolt head 8" into
slot in wheel tray.
• Use the washers and wing
nut to attach the hoop
baseplate onto this bolt.
• Slide one SnapAround bolt
into the track at the other
end of the wheel tray.
Red Knob and Jaws Assembly
Install red knob:
• Choose access from passenger or
driver side.
• Red knob should face you when
the Raptor is attached to wheel tray.
THREADED GUIDE
PLUG
PLUG
Jaws
Red Knob
Tighten knob completely until
threaded end is exposed.
1033038B-2/12
8"
(REAR)
• Place the GUIDE PLUG into the
hole on one side of the jaws.
• Slide the red knob's bolt threads
through the guide plug.
GUIDE
PLUG
Slide the "E"clip into groove on end.
A coin or a key may
provide added
leverage.
An extra clip
is included.
ON SOME SMALLER BIKES—
If the wheel straps need to be between
Slide the open wheel
the crossbars, slide them onto the wheel
straps onto the wheel
tray now. If not, install them after the
tray with the red
next step.
buttons towards you.
STANDARD BIKES:
Place wheel straps
outside the crossbars.
Insert the THREADED PLUG
into the other hole.
• Place spring between guide
plug and threaded plug.
• Slide knob through spring
and into threaded plug.
THREADED
PLUG
Spring
Open red knob
completely.
SMALLER BIKES:
Wheel straps may
need to go between
the crossbars.
Turn the red knob
clockwise to engage
the threaded plug .
SKS ® Lock Cores are optional.
To install SKS ® Lock
Cores, refer to lock
instructions.
NOTE:
If not using lock, leave plug in.