Publicidad
Idiomas disponibles
Idiomas disponibles
Install wheel assembly with tray onto crossbars.
Do you have round,
square or factory
crossbars?
IF ROUND, continue to:
for Factory crossbars,
use MIGHTYMOUNTS.
• Set tray/hoop assembly onto
crossbars.
• Insert two bolts up through the
SnapArounds and baseplate.
• Secure with elongated hex
keys.
• Insert the remaining bolt
through the SnapAround on the
other crossbar.
• Secure with shorter hex key.
Securing your bike.
Set your bicycle in the wheel
tray with the hoop lying flat
between the wheels.
NOTE: The front wheel
of the bicycle must rest
inside the hoop.
1033038B-3/12
If you have
SQUARE BARS,
loosen the tabs
by bending them
repeatedly.
• RAISE hoop
• ROLL bicycle
forward as jaws
meet the down tube.
Remove the tabs with
scissors or pliers.
Tighten all 3 hex keys firmly onto
all SnapArounds.
NOTE:
Hoop must rest horizontally on tray
while turning the hex keys.
When hoop is raised the hex keys
cannot be turned.
In the open position, Jaws should clear the bike
frame. Raptor can mount above or below most
attachments, such as waterbottles.
SOME attachments on the down tube must be
removed if the jaws cannot attach above or
below them.
Attach 2 SnapArounds on
the front crossbar and 1 on
the back crossbar.
Install end caps.
Tighten red knob.
NOTE:
To avoid
paint wear,
clean contact
points on
frame before
tightening
Jaws.
Do not
overtighten.
Publicidad
