English
The Oral-B Professional Care OxyJet
irrigator mixes air into water in the form of
micro-bubbles. These micro-bubbles in the
water stream attack plaque bacteria.
At the same time, it removes remaining food
particles from between your teeth and mas-
sages your gums. Always use the irrigator
after brushing your teeth.
Please read the use instructions carefully
before first use.
Important
The appliance must be mounted in a way that
it cannot fall into water.
The plug should always be accessible.
Periodically check the cord for damage.
A damaged or non-functioning unit should
no longer be used. Take it to a Braun Service
Centre.
Description
Irrigator jet
a
Jet switch
b
Jet compartment
c
Jet release button
d
On/off switch
e
Water pressure control dial
f
g
Handle switch (water stop and go)
Irrigator handle
h
Water container (600 ml / 20 fl. oz.)
i
Specifications
Power supply: see bottom of housing
Power intake: 24 W
6
®
Using the OxyJet
Before using for the first time, fill the water
container and allow the water to run through
completely by holding the irrigator handle
over a washbasin.
1. Attach one of the irrigator jets to the
handle until it locks in place. Fill the water
container with water and add mouthwash,
if desired.
2. Turn on the irrigator by pressing the on /off
switch. ( When doing so, the handle switch
should be in the lower position = water
stop.)
3. Select the water pressure with the pres-
sure control dial ( 1 = gentle, 5 = strong ).
We recommend that you start with set-
ting 1, especially if your gums tend to
bleed or if children are using the irrigator.
4. Bend over the washbasin and guide the jet
to your teeth and gums. Slide the handle
switch up to start the water stream. Keep
your mouth slightly open to allow the water
to run into the washbasin.
You can choose between two different jet
functions by sliding the jet switch down
or up (before doing so, turn off the water
stream by pushing the handle switch down):
®
Irrigator