Twin Star 75089/23MM9065-NB75 Manual De Instrucciones página 10

8. Locate Side Back Panel (M) and Center Back Panel
(L), attach to the back of the completed assembly
from step 7. Use a Phillips Head screw driver,
tighten screws (EE) through the pre-drilled holes in
the Back Panels to the completed assembly.
Hardware Used
EE
Wood Screw
9. Locate Right Front Door (P) and Left Front Door
(O). Slide door hinge keyhole into panel hinge
bracket. (Diagram 1)
Use Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change
keyhole slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen / tighten screw.
(As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c)
Attach the Knob (DD) to the Left Front Door (O)
and Right Front Door (P), use the bolts attached
through the pre-drilled holes in the doors. Then use
a Phillips Head Screwdriver to tighten the bolts.
Hardware Used
DD
Knob (with bolt)
GG
Euro Hinge
10. Choose desired height of shelf and place the four
Shelf Pins (FF) into same height shelf holes inside
side Panels. Insert Wood Shelf (H), allow Wood
Shelf (H) to rest on the Shelf Pins (FF).
Hardware Used
FF
Shelf Pin
Fig. 8
x 28
Fig. 9
x 2
x 4
Fig. 10
x 8
9
EE
L
M
P
O
H
FF
M
DD