Preparaion; Assembly Instruction - Twin Star 75089/23MM9065-NB75 Manual De Instrucciones

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts
with package contents list and diagram above. If any part is missing or damaged, do not
attempt to assemble, install or operate the product. Contact customer service for
replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors
and utility knife
ASSEMBLY INSTRUCTIONS
Camlock installation.
For correct installation, screw A-1 must be inserted
and tightened in the pre-drilled hole. Camlock A-2
must be inserted into the pre-drilled hole with the
cross positioned in the direction of screw A-1.
1. Locate the Center Left Front Panel (I), Center Left
Side Panel (B), and set out face down on a
scratch-free surface. Insert Wood Dowel (CC) and
screw (A-1) into the holes in the Left Front Panel,
make sure to tighten (A-1). Push Center Left
Front Panel (I) snug to the Center Left Side Panel (B).
Use a Phillips head screwdriver to tighten (A-2).
Repeat with Center Right Front Panel (J) and Center
Right Side Panel (C).
Hardware Used
Camlock
AA
(A-1,A-2)
Wood Dowel
CC
Fig. 1
x 4
x 4
6
A-1
A-2
I
J
CC
CC
C
B