Before Using; Height Of Cut Adjustment; Starting And Stopping - Bosch ARM32 Manual Del Usuario

Electrical Safety
Your machine is double insulated for safety and requires
no earth connection. The operating voltage is 230V ac,
50Hz. Only use an approved extension cable. Contact
your service agent for details. It is recommended for
increased electrical safety to use a Residual Current
Device (RCD) with a tripping current of not more than
30mA. Always check your RCD every time you use it.
WARNING: For safety, it is essential that the power
connector 3 attached to the machine is fitted to the pow-
er supply cable 14 as in illustration C.
The couplings of connection leads must be protected
against splashes and the coupling sockets on the leads
must be made of rubber or coated with rubber.
Fixing means for the connection leads must be used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if in
perfect condition.
Note: Your mower is fitted with an approved
13A(BS1363/A) electric plug and is protected by a 13A
fuse (ASTA Approved to BS1362).
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its
place.
The severed plug must be disposed of to avoid a possi-
ble shock hazard and should never be inserted into a
13A socket elsewhere.

Before Using

Assembly
Attach cable restraint 8 to handle bottom 15 (ARM32E)
as in illustration A.
Raise the height of cut to setting 7 (65mm). See Height
of Cut Adjustment.
Fit the handle bottom 15 to the mower as in illustration
A. Line up the holes of the handle bottom and mower
and fit plugs 16 as in illustration A, ensuring that they
are fully inserted.
Fit the handle top 17 to the handle bottom using the
handle wheels 18 and bolt 19 as in illustration A.
Ensure that the cable clips 20 are attached around the
intermediate cable 21 before fitting to the handles.
Fit the cable clips 20 as in illustration A.
Fit the grassbox top and bottom together as in illustra-
tion B.
Attach cable to cable restraint 8 as in illustration C, en-
suring that there is sufficient cable slack between con-
nector and cable restraint.
14
Grassbox
For non grass collection the mower can be used with-
out the grassbox in position, with the deflector guard in
the down position.
Fitting
Lift the deflector guard 6 and hold up, illustration D.
Fit the grassbox 10, illustration D.
Removing/ Emptying
Lift the deflector guard 6 and hold up - remove grassbox
10, illustration D.

Height of Cut Adjustment

Stop, release switch lever before adjusting
height.
Your machine has seven settings which give the follow-
ing approximate height of cuts:
1 = 18 mm 2 = 22 mm 3 = 27 mm
5 = 40 mm 6 = 50 mm 7 = 65mm
Remove the grassbox to aid adjustment (see Grass-
box)
Press and hold the height of cut button 11 as in illustra-
tion E.
Lift up or push down the machine as in illustration E
until the required height is indicated 12.
Release the height of cut button 11 to lock the height of
cut setting, a click will be heard when locked.

Starting and Stopping

To aid starting push handle down to lift front
wheels.
Starting
Press and hold the safety button 1,
illustration F.
Squeeze the switch lever 2 towards the han-
dle.
Release the safety button 1.
Stopping
Release the switch lever 2.
4 = 32 mm