Technical Data - Martin Yale papermonster LA3 Instrucciones De Uso

Translation of the Original Operation Manual
GB
Übersetzung der Originalbetriebsanleitung
- Pls insert the film with material to laminate
flatly into the laminating insert. The laminat-
ing finish will come out from the rear exit.
PROBLEMS
1. When the Machine is in blue indicator, the inat-
ing material doesn't come out from the exit after
inserting for a long time, and there is noise as
well as bad smell coming from the machine.
2. The power indicator is not on.
3. If other problems happen, pls plug off the machine and send it to maintenance centre.
DISPOSING
DISPOSING OF THE MACHINE:
Dispose of the machine
environmentally sound fashion at the
end of its useful service life. Do not
dispose of any of the parts included
in the machine or its packaging with
household trash.
LAMINATING PROCESS
- Take out the laminating finish and check the
result. If there is darkness on the surface
which means the film was not well laminated,
pls laminate it again.
Figure 2
BRIEF PROBLEM SHOOTING
1. Improper use of laminating film, such as: une-
ven laminates edges on the film which makes the
roller stuck with glue; you reserve too much area
in the front of the film; the laminated thickness
has exceeded the max. laminating thickness.
2. There is a barrier at the rear exit.
1. The machine is not yet plug in;
2. The power switch is not switched on;
3. The electric current fuse has been destroyed.
Power consumption:
in an
Max. laminating width:
Max. laminating thickness:
Preheating time:
Working time:
Laminating speed:
Qty. of roller:
Net Weight:
Dimensions (L*W*H):
REASONS

TECHNICAL DATA

220 V - 240 VAC, 50 Hz
330 mm
(125 x 2) mic + 160 gsm paper
3–5 min.
30 min. on, 30 min. off
300 mm/min.
2
1.8 kg
440 x 135 x 67 mm
5
MAINTENANCE
- Beforeandafterlaminating,youmayinsert1 pc
of white paper so as to take out the possible
dust in the roller.
- Don't clean the surface of the machine with cor-
rosive solvent. Don't drop any water inside
the machine when cleaning the machine with
a wet cloth, otherwise, it may led to problems
in PCB.
- If the machine is unused for a long time, pls cov-
er up the machine with a plastic or cloth to get
rid of the dust.
SOLUTIONS
Please switch off the power and unplug the ma-
chine, pull out the jammed films from the insert;
if there is still any problem, please turn to profes-
sional for maintenance.
Pls check and make sure if the machine is plug
in or not and if the power switch is switched on
or not, or pls ask the maintenance personnel to
check the circuit; otherwise, pls send the ma-
chine to maintenance centre.
LAMINATOR
LA3