Technical Data - Martin Yale papermonster LA3 Instrucciones De Uso

GB
2. Pls insert the film with material to laminate
flatly into the laminating insert. The laminat-
ing finish will come out from the rear exit.
Figure 2
- Take out the laminating finish and check the
result. If there is darkness on the surface
which means the film was not well laminated,
pls laminate it again.
PROBLEMS
1. When the Machine is in blue indicator, the lam-
inating material doesn't come out from the exit
after inserting for a long time, and there is noise
as well as bad smell coming from the machine.
2. The power indicator is not on.
3. If other problems happen, pls plug off the machine and send it to maintenance centre.
MALFUNCTION
DISPOSING OF THE MACHINE:
Dispose of the machine in an envi-
ronmentally sound fashion at the
end of its usefull service life. Do not
dispose of any of the parts included
in the machine or its packing with
household trash.
Description
XXXXX
Note: For orders of special accessoires and spare parts, please contact your dealer.
Power consumption:
Max. laminating width:
Max. laminating thickness:
Preheating time:
Working time:
Laminating speed:
Qty. of roller:
Net Weight:
Dimensions (L*W*H):
OPERATING GUIDE
BRIEF PROBLEM SHOOTING
1. Improper use of laminating film, such as: une-
ven laminates edges on the film which makes the
roller stuck with glue; you reserve too much area
in the front of the film; the laminated thickness
has exceeded the max. laminating thickness.
2. There is a barrier at the rear exit.
1. The machine is not yet plug in;
2. The power switch is not switched on;
3. The electric current fuse has been destroyed.
SPECIAL ACCESSOIRES

TECHNICAL DATA

220 V - 240 VAC, 50 Hz
330 mm
(125 x 2) mic + 160 gsm paper
3–5 min.
30 min. on, 30 min. off
300 mm/min.
2
1.8 kg
440 x 135 x 67 mm
LAMINATOR
Notice
1. When the machine is working,
pls try not to touch the housing in
order not to get hurt.
2. The socket-outlet shall be in-
stalled near the equipment and
shall be easily accessible.
REASONS
Order-No.
5
MAINTENANCE
1. After using the machine, pls plug off the ma-
chine and pls don't cover up the small holes
so as to let out the heat.
2. Don't place heavy ore sharp materials onto
the machine in order not to distort or damage
the machine.
3. Before and after laminating, you may insert
1 pc of white paper so as to take out the pos-
sible dust in the roller.
4. Don't clean the surface of the machine with
corrosive solvent. Don't drop any water inside
the machine when cleaning the machine with
a wet cloth, otherwise, it may led to problems
in PCB.
5. If the machine is unused for a long time, pls
cover up the machine with a plastic or cloth to
get rid of the dust.
SOLUTIONS
Please switch off the power and unplug the ma-
chine, pull out the jammed films from the insert;
if there is still any problem, please turn to profes-
sional for maintenance.
Pls check and make sure if the machine is plug
in or not and if the power switch is switched on
or not, or pls ask the maintenance personnel to
check the circuit; otherwise, pls send the ma-
chine to maintenance centre.
xxxxx
LA3