Preparation/ Getting Started; Basic Operations; Auxiliary Input - Kenwood KDC-DAB43U Guia De Inicio Rapido

Preparation/ Getting Started

Volume knob
Turns the power ON
Detaches the faceplate
How to read this manual
Operations explained mainly using buttons
on the faceplate.
• [ ] indicates the buttons on the panel.
• XX indicates the selected items.
How to attach/detach the faceplate
2
1
1
2
• Do not expose the faceplate to direct
sunlight, excessive heat, or humidity. Also
avoid places with too much dust or the
possibility of water splashing.
• Keep the faceplate in its casing while
detached.
• The faceplate is a precision component of
the unit and can be damaged by shocks
or jolts.
• To prevent deterioration, do not touch
the terminals of the unit and faceplate
with your fingers.
Cancel the display demonstration
The display demonstration is always turned
on unless you cancel it.
When you turn on the power (or after you
reset the unit), the display shows:
"CANCEL DEMO" X "PRESS" X
"VOLUME KNOB"
1
Press the volume knob.
"YES" is selected for the initial setting.
2
Press the volume knob again.
"DEMO OFF" appears.
• If no operation is done for about 15 seconds
or if you turn the volume knob to select "NO"
in step 2, "DEMO MODE" appears and the
display demonstration starts.
Setting the clock
1
Press [SCRL DISP] repeatedly to
select the clock.
2
Press and hold [SCRL DISP] to enter
clock adjustment mode.
3
Turn the volume knob to adjust the
hour, then press to enter minute
adjustment.
4
Turn the volume knob to adjust the
minute, then press the knob.
– Press [E] / [F] to move between
the hour and minute adjustment.

Basic Operations

Volume knob
Turning the power ON/OFF
Press [8SRC] to turn the power on.
Press and hold [8SRC] to turn the
power off.
Selecting a source
Press [8SRC] repeatedly to select
your desired source.
Digital radio ("DAB") Á Analog radio
("TUNER") Á USB or iPod ("USB" or "iPod")
Á CD ("CD") Á Auxiliary input ("AUX") Á
Standby ("STANDBY")
Adjusting the volume
Turn the volume knob to adjust the
sound volume.
Switching display
Press [SCRL DISP] repeatedly to select
an information.

Auxiliary input

1
Open the cover.
2
Connect a portable audio device
using a stereo mini-plug (3.5 mm ø)
audio cable.
USB terminal
Auxiliary input
USB terminal
1
Open the cover.
2
Connect a USB device or iPod to the
USB terminal.
(USB terminal Maximum Supply current:
DC 5 V = 1 A)
USB device
USB device
2 (commercially
available)
1
CA-U1EX (500 mA Max.: optional
accessory) is recommended to connect
a USB device.
iPod
Apple iPod
(commercially
available)
2
1
KCA-iP102 connector (optional
accessory) is required to connect an
iPod.
English | 3