Tabla de contenido
Publicidad
Hawa Concepta 35 pre-mounted
2 Product information
Intended use
Pivot/slide-in hardware for laterally retractable wooden doors for cabinets or wall recesses.
Intended place of use
Dry internal areas and internal areas where condensation can occur, e.g. in the kitchen or bathroom, but without any significant
chloride burden.
Technical data
Hawa Concepta 35 pre-mounted
Maximum door weight
Door width
Door height
Door thickness
■
Maximum permissible deflection of the hardware assembly face and door ± 2 mm ( ").
Use the straightening fitting for stabilizing sliding doors. Straightening fitting, max. length 1650 mm (5'4 ").
Certificates are available for downloading at www.hawa.com.
Article number
Articles are identified by a 5-digit number.
General notes
These instructions were created for assembling the hardware. Prior planning occurs in direct cooperation between
Hawa Sliding Solutions AG and the customer.
Mounting is shown for a left-handed system. The applicable instructions for mounting a right-handed system are additionally shown
The document «Safety Instructions» (22991) is an integral component of these installation instructions.
Metric dimensions in mm apply - inches are for information only.
Please retain these instructions; replacements are available from www.hawa.com.
Risk and residual risk hazard
If using Hawa Concepta 35 pre-mounted to conceal electrical appliances, ensure compliance with the safety notes provided by the
appliance manufacturer (heat accumulation). If necessary, use an automatic shutoff device (e.g. Safety Box, www.halemeier.de).
Disposal
Materials, accessories and packaging should be recycled in an environmentally friendly manner.
3 Safety instructions
The symbols for notes relevant to safety (hazard warnings) as used in these assembly instructions have the following meanings:
CAUTION
Indicates a possible danger with a moderate risk that can result in death or (serious) physical injury if not avoided.
CAUTION
Moving parts can crush fingers.
– Do not touch moving parts!
8/52
(77 lbs.)
35 kg
(11 "– 2'5 ")
13
300 – 750 mm
---- -
16
1950 – 2300 mm (6'4 "– 7'6 ")
25
---- -
32
3
( "– ")
7
19 – 22 mm
--
--
4
8
17
---- -
32
9
---- -
16
3
---- -
32
31
---- -
32
Publicidad
Tabla de contenido
