Celestron HomeCast LITE Manual Del Usuario página 5

sEt UP
Weather station
Open the battery compartment door (C2) on the rear of the Weather Station. Then insert
two AA batteries (user supplied) with polarity as indicated in the battery compartment.
Press the reset button (B8), using a paperclip or a similar small pointed device. The
Weather Station will begin to scan the 433MHz radio frequency.
remote sensor
Open the battery compartment door (D5) on the rear of the Remote Sensor using a screw
driver or a thin coin. Insert two AAA batteries (user supplied) with polarity as indicated
in the battery compartment. Set the Channel Switch (D4) to 1. Press the TX button (D7)
and hold for 2 sec. to "transmit" signal to Weather Station. The Weather Station will
beep, confirming the signal has been received and a temperature readout will appear in
the outdoor temperature window (A2). Press the °C/°F button (B6) to set your desired
temperature reading mode. The Sensor can be mounted up to 100 feet (30 meters) in an
open area from the Weather Station to communicate with it. The Sensor can be mounted
to a wall with a screw or nail (D3) or set on a flat level surface using the fold-out stand (D8).
The Sensor has a small LCD screen that displays the outdoor temperature (D2). To select
the °C or °F temperature reading press button (D6).
5