Vetus RCTOPB Instrucciones De Instalación página 5

Housing and Lever
When selecting the place where the housing and lever will be mounted, account for the maximum swing that the lever can make.
Also account for the total height of the mechanism. See drawing 'Principal dimensions'.
Top mounting:
• With the help of the supplied drill pattern,sketch
the mounting holes to be drilled and the opening to be sawed out.
• The two brackets on part
sure that the mounting holes line up with the sketched holes.
• Drill the holes and saw out the opening.
• Apply the supplied self-stick spacer
• Assemble the remote control with M5 bolts of the correct length.
• Now assemble part of the housing.
• Grease the axle of the mechanism , and mount the lever in the desired position (usually vertical).
• Provide the bolt M10 with a screwlock (Loctite
• Check the path of the cables.
Side mounting:
The remote control for side mounting requires a space of at least 180 mm
(7") behind the shot in order to assemble the entire mechanism.
• With the help of the supplied drill pattern, sketch the mounting holes to
be drilled and the opening to be sawed out.
• Drill the holes and saw out the opening.
• Apply the supplied inseal
inset.
• Attach the mechanism
• Then attach the entire mechanism to the shot with bolts.
• Grease the axle of the mechanism, and mount the lever in the desired
position (usually vertical).
• Provide the bolt M10 with a screwlock (Loctite
• Check the path of the cables.
Adjustments
Screw 1 can be adjusted to set the friction
for the gas mechanism, depending on the
counter pressure of the throttle.
Control
Button 2 can be used to turn off the control
of the gearbox, so that gas can only be
given. (For example, for starting and warm-
ing up the engine.)
When the lever is returned to the neutral
position, the button will pop back out, and
the remote control is ready for normal use.
Mechanische motorafstandsbediening
should serve as mounting brackets. Make
in the correct manner.
® 243).
correctly on the back of plate
to plate .
® 243).
. See
Maintenance
Clean, as necessary, the lever and the housing with freshwater.
Check the mechanism for loose components and for wear of
the moving parts on a regular basis.
Apply a water-resistant lubricant to the moving parts routinely.
Check the cables and the cable connections for wear and cor-
rosion on a regular basis.
ENGLISH
5
030606.07