Preparation For Use - 3M SecureFit X5500NVE Manual Del Usario

GZXO
INTENDED USE
The 3M™ X5000 and X5500 SecureFit™ Safety Helmets are designed to
protect the wearer against objects likely to strike the head in industrial and
occupational use.
The X5500 is certified to EN397:2012+A1:2012, Industrial Safety Helmets,
and is designed to be used for general industrial use. The X5000 is certified to
EN12492:2012 Helmets for Mountaineers, and certified to EN397 and is designed to be
used for working at height and rescue as well as for general industrial use.
Note that X5000 is either in EN12492 mode or in EN397 mode but cannot meet both
EN-standards simultaneously. For specific performance features see section Technical
Specification. See all instructions for use and save for continuing reference.
^ Particular attention should be given to warning statements where indicated.
^ WARNING
• Always be sure that the complete product is: - Suitable for the application; - Fitted correctly;
- Worn during all periods of exposure; - Replaced when necessary.
• Proper selection, training, use and appropriate maintenance are essential in order
for the product to help protect the wearer from impact hazards.
• Failure to follow all instructions on the use of these personal protection products
and/or failure to properly wear the complete product during all periods of exposure
may adversely affect the wearer's health, lead to severe or life threatening illness or
permanent disability.
• For suitability and proper use follow local regulations and refer to all information
supplied. For more information contact a safety professional or 3M on 0870 60 800 60
(UK) or 1800 320 500 (Ireland).
• For adequate protection this helmet must fit or be adjusted to the size of the users head.
• The helmet is made to absorb the energy of a blow by partial destruction or damage to the
shell and the suspension, and even though such damage may not be readily apparent, any
helmet subjected to severe impact should be replaced.
• The attention of users is also drawn to the danger of modifying or removing any of the
original component parts of the helmet, other than as recommended by the helmet
manufacturer. Helmets should not be adapted for the purpose of fitting attachments in any
way not recommended by the helmet manufacturer.
• Do not apply paints, solvents, adhesives or self-adhesive labels, except in accordance with
instructions from the helmet manufacturer.
• Direct contact with sprays, fluids or other substances containing solvents and/or alcohols
can reduce the durability of the helmet and should therefore be avoided.
• Do not use helmets for applications other than for general industrial use (EN397), working
at height, rescue or mountaineering (EN12492).
• Always ensure that the head suspension is well maintained and correctly adjusted to the
user's head.
• If in doubt contact your safety officer or 3M for further advice.

PREPARATION FOR USE

Selection
The selection of the appropriate helmet should be based on a risk assessment of the
12