Start Up; Rotation Direction - Truper DETA-N Manual De Instrucciones

Start Up

Tip Fitting
• Set the tip inside the tip holder until it stops. The
magnetic tip will get fixed automatically.
Start Up and Operation Control
• Intermittent operation:
Connect the plug into the power outlet.
Press the switch (A) to start the screwdriver.
Speed increases when applying more pressure on the switch.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power outlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.
CAUTION
During the operation the motor will be running but the tip
will not turn until the screw applies pressure in the material. This feature is
useful to insert the screw in the tip before screwing it into the material.
Speed Control
• The tool operation speed is controlled when pressing the
switch. Upon applying more pressure on the switch the
rotation speed and torque are increased.

Rotation Direction

• The screwdriver rotation direction is controlled by the rotation
direction selector button (C). This function enables the screwing and
unscrewing function.
• To screw press the button with the arrow pointing towards the tip
holder.
• To unscrew press the button with arrow pointing towards the
handle .
Screwing depth adjustment
• The depth stop can be adjusted in order to screw the screws at a specific
depth determined by the job to be done.
• Thread the depth control knob to the desired position (1).
• For more precise jobs, screwing depth control allows to fine-tune
adjusting the depth stop position.
• The adequate depth can be better determined making some tests on scrap
material until getting the desired depth.
C
A
Deeper
1
ENGLISH
B
7