Publicidad
Idiomas disponibles
Idiomas disponibles
1. Lower exhaust by detaching it from rubber isolators (qty. 2). Spraying lubricant on
rubber isolators eases removal.
3. Raise hitch into position while feeding the pullwire through
the attachment slot on the driver side of the hitch.
©2015 Cequent™ Performance Products, Inc. -
Printed in Mexico
2. Install 7/16" bolt and spacer into driver side frame rail using
the pull wire procedure (figure 2). Leave pull wire attached at
this time.
*Photo is pullwire example, actual vehicle may look different
4. Hang the U-bolt around the tow hook and through the holes on chain
plate behind the receiver, install the 3/8" flatwasher, lockwasher and hex
nut. Center the hitch on the vehicle.
Sheet 4 of 15
24932NP
6-15-15
Rev. A
Publicidad
