Publicidad

Idiomas disponibles

Idiomas disponibles

Cequent
Performance Products, Inc.
Website: www.cequentgroup.com
Technical Assistance: 800-632-3290
TechnicalSupport@cequentgroup.com
To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE:
ALWAYS read, understand and follow warnings and instructions
for your hitch BEFORE installation. Keep for future reference.
DO NOT cut, weld or modify this receiver.
CHECK all fasteners are tight and your hitch is securely mounted
to your vehicle periodically.
ALWAYS read, understand and follow all warnings and
instructions for your vehicle and for other accessories you will use
with your hitch BEFORE use.
LOAD the trailer heavier in front.
DO NOT exceed lower of towing vehicle manufacturer's rating or:
Hitch Type
Max Gross Trailer
Weight Carrying
2000 lb. (908 kg)
Weight Distributing
ALWAYS wear your seatbelt.
SLOW DOWN when towing, NEVER exceed any posted speed limit.
If EXCESS SWAY occurs, take your foot off the gas pedal and hold
the steering wheel as steady as possible. DO NOT apply your
brakes and DO NOT speed up.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 24940, 77327
Max Tongue
Weight
Weight
200 lb. (90.8 kg)
X
X
LIMITED LIFETIME WARRANTY
1.
Limited Lifetime Warranty ("Warranty"). Cequent Performance Products, Inc. ("We",
"Us" or "Our") warrants to the original consumer purchaser only ("You" or "Your") that the
product will be free from material defects in both material and workmanship, ordinary wear
and tear excepted. The Warranty is valid only if (a) the products are returned to Us for
inspection and testing; (b) Our inspection discloses to Our satisfaction that any alleged
nonconformance are material and have not been caused by misuse, neglect, wear and tear,
improper installation, unsuitable storage, improper repair, alteration, or accident; and (c) the
products were installed, maintained and used in accordance with Our instructions. THE
WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED (OTHER THAN THE WARRANTY OF TITLE AS PROVIDED BY THE
UNIFORM COMMERCIAL CODE IN EFFECT IN MICHIGAN), INCLUDING
WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE, SAID WARRANTIES BEING EXPRESSLY
DISCLAIMED.
2.
Obligations of Purchaser. To make a Warranty claim, contact Us at our principal address of
47912 Halyard Drive, Suite 100, Plymouth, MI 48170, 1-800-632-3290, identify the product
by model number, and follow the claim instructions that will be provided. Any returned
product that is replaced by Us becomes our property. You may be responsible for return
shipping costs. Please retain your purchase receipt to verify date of purchase and that You
are the original consumer purchaser. The product and the purchase receipt must be provided
to Us in order to process Your Warranty claim.
3.
Exclusive Remedy. Product replacement is Your sole and exclusive remedy under this
Warranty. We shall not be liable for service or labor charges incurred in removing or
replacing a product. IN NO EVENT WILL WE BE RESPONSIBLE FOR ANY INDIRECT,
SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES.
4.
Assumption of Risk. You acknowledge and agree that any use of the product for any
purpose other than the specified use(s) stated in the product instructions is at Your own risk.
5.
Governing Law. This Warranty gives You specific legal rights, and You also may have
other rights which vary from state to state. This Warranty is governed by the laws of the
State of Michigan, without regard to rules pertaining to conflicts of law. The state courts
located in Oakland County, Michigan shall have exclusive jurisdiction for any disputes
relating to this Warranty.
Rev 9/2014
Sheet 1 of 24
Scan for safe
towing tip, or visit
http://www.ceque
ntgroup.com/qr-
product.aspx
24940N
3-14-16
Rev. A

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Cequent Performance Products 24940

  • Página 1 TechnicalSupport@cequentgroup.com product.aspx LIMITED LIFETIME WARRANTY Limited Lifetime Warranty (“Warranty”). Cequent Performance Products, Inc. ("We", “Us” or “Our”) warrants to the original consumer purchaser only ("You" or “Your”) that the To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE: product will be free from material defects in both material and workmanship, ordinary wear •...
  • Página 2: Installation Instructions

    ™ Cequent Performance Products, Inc. Installation Instructions Website: www.cequentgroup.com PART NUMBERS: 24940, 77327 Technical Assistance: 800-632-3290 TechnicalSupport@cequentgroup.com Applications: Installation Time: 40 min Years Make Models The time listed above is the average time for professional installers. If you do not...
  • Página 3 Fastener Kit: 24940F Installation Instructions ① (Sold separately) Carriage Bolt ① ③ Qty. (2) Drawbar Kit: 3593 PART NUMBERS: 24940, 77327 3/8-16 x 1.00 Gr5 Carriage Bolt Drawbar must be ② Qty. (2) 3/8-16 x 1.25 Gr5 ② used in the RISE Special Washer ③...
  • Página 4 Installation Instructions Kia Optima PART NUMBERS: 24940, 77327 muffler heat shields NOTE: First, cut 1-1/2” wide x 1” tall area to fit Figure 7 Figure 8 around hitch bolt. 1” 1” 1-1/2” 1-1/2” 11” 9” 11” 9” Measure 1-1/2” Measure 1-1/2”...
  • Página 5 Installation Instructions PART NUMBERS: 24940, 77327 5” 2” Keep this Attachment hole 2-3/8” 9-1/4” Vehicle Forward 1/2” Passenger‘s side muffler heat shield shown Driver’s side opposite Plastic appearance panel Hyundai Sonata Optional trim or return to owner muffler heat shields...
  • Página 6 1. Lower mufflers – Lower muffler(s) down by removing the rearmost 2. Remove factory muffler hanger bracket(s) - Remove (2) hex nuts per rubber hanger(s) and the rubber hanger near rear axle. A spray a hanger bracket to remove. Return bracket(s) and fasteners to vehicle lubricant on rubber hangers makes them slide off metal pins more owner.
  • Página 7 5. Remove heat shield(s) – Remove the hex nuts (3 to 5 per heat shield) 6. Install rear attachment fasteners - Using 3/8 pull wires provided, fish wire 3/8-16 x 1-1/4” long carriage bolts and special washers (item 3) holding heat shield(s) to bottom of vehicle. NOTE: Shield(s) will be through 7/8”...
  • Página 8 10. Raise hitch into position - Install 3/8 conical toothed washers and 11. Tighten all 3/8-16 Gr5 fasteners with torque wrench to hex nuts on forward carriage bolt attachments. Install spacer blocks Proper torque is needed to keep the hitch secure 30 Lb.-Ft.
  • Página 9: Garantie À Vie Limitée

    GARANTIE À VIE LIMITÉE Garantie à vie limitée (« Garantie »). Cequent Performance Products, Inc. (« Nous », « Notre ») garantit à l’acheteur initial seulement (« Vous », « Votre ») que le produit sera Pour prévenir les blessures SÉVÈRES, FATALES ou les DOMMAGES exempt de vices de matières et de fabrication, exception faite de l’usure normale.
  • Página 10 ™ Cequent Performance Products, Inc. Instructions d’installation Site Internet: www.cequentgroup.com NUMÉROS DE PIÈCES : 24940, 77327 Assistance technique: 800-632-3290 TechnicalSupport@cequentgroup.com Applications : Durée de l'installation : 40 min Années Marque Modèles La valeur indiquée ci-dessus est la durée moyenne des installeurs professionnels.
  • Página 11 Instructions d’installation ① Boulon de carrosserie ① Qté (2) ③ 3/8-16 x 1.00 Gr5 NUMÉROS DE PIÈCE : 24940, 77327 (Vendu séparément) Boulon de carrosserie ② Qté (2) Ensemble de barre de remorquage : 3593 3/8-16 x 1.25 Gr5 ②...
  • Página 12 Instructions d’installation Kia Optima NUMÉROS DE PIÈCE : 24940, 77327 Écrans thermiques des silencieux. NOTA : En premier, découper une zone de 1 1/2 po de large Figure 7 Figure 8 par 1 po de haut pour dégager le boulon d'attelage.
  • Página 13 Instructions d’installation NUMÉROS DE PIÈCE : 24940, 77327 5” 2” Conserver ce trou de fixation. 2-3/8” 9-1/4” Avant du véhicule 1/2” Écran thermique du silencieux côté passager illustré Disposition opposée du côté conducteur Panneau décoratif en plastique. Hyundai Sonata Découpage facultatif ou remettre au propriétaire.
  • Página 14 2. Enlever les ferrures des support(s) en caoutchouc - Retirer deux (2) écrous 1. Abaisser les silencieux – Abaisser le(s) silencieux en enlevant le(s) hexagonaux par ferrure. Remettre les ferrure(s) et la visserie au propriétaire support(s) en caoutchouc les plus à l'arrière et le support en du véhicule.
  • Página 15 5. Enlever le(s) écran(s) thermique(s) – Retirer les écrous hexagonaux 6. Poser la visserie arrière - À l'aide des fils de tirage 3/8 fournis, acheminer les boulons de carrosserie longs 3/8-16 x 1-1/4 po et les rondelles spéciales (3 à 5 par écran) qui fixent les écrans dans le bas du véhicule. NOTA : Les (art.
  • Página 16 10. Soulever l'attelage en position - Poser les rondelles coniques dentées 11. Serrer toute la visserie 3/8-16 Gr5 au couple de 30 lb-pi (41 N.m). 3/8 et les écrous hexagonaux sur les boulons de carrosserie avant . Poser Un couple de serrage adéquat est essentiel pour bien fixer l'attelage au les blocs espaceurs (art.
  • Página 17: Garantía Limitada De Por Vida

    GARANTÍA LIMITADA DE POR VIDA Garantía limitada de por vida ("Garantía") Cequent Performance Products, Inc. ("nosotros", Para evitar DAÑOS DE GRAVEDAD, A LA PROPIEDAD O LA MUERTE: "nos" o "nuestro/a/s") garantiza al comprador original únicamente ("usted" o "su/s") que el producto estará...
  • Página 18: Equipo Necesario

    ™ Cequent Performance Products, Inc. Instrucciones de instalación Sitio web: www.cequentgroup.com NÚMEROS DE PARTES: 24940, 77327 Assistance técnica: 800-632-3290 TechnicalSupport@cequentgroup.com Aplicaciones: Tiempo de instalación: 40 min Años Marca Modelos El tiempo indicado anteriormente es el tiempo promedio para instaladores 2011 -Actual* Kia Optima profesionales.
  • Página 19 (Se vende por separado) Perno de carruaje, ① ③ Cant. (2) Kit de barra de tracción: 3593 3/8-16 x 1.00 GR5 NÚMEROS DE PARTE: 24940, 77327 Perno de carruaje, La barra de tracción ② Cant. (2) 3/8-16 x 1.25 GR5 ②...
  • Página 20 Instrucciones de instalación Kia Optima NÚMEROS DE PARTE: 24940, 77327 protectores térmicos del silenciador NOTA: Figura 7 Figura 8 Primero, recortar un área de 1-1/2" de ancho x 1" de alto para colocar alrededor del perno del enganche. 1” 1”...
  • Página 21 Instrucciones de instalación NÚMEROS DE PARTE: 24940, 77327 5” Mantener este orificio de unión 2-3/8” 2” 9-1/4” Frente del vehículo 1/2” Se muestra el protector térmico del silenciador lado del pasajero Opuesto al lado del conductor Panel de apariencia plástico...
  • Página 22 1. Bajar silenciadores: Bajar el(los) silenciador(es) al quitar el(los) colgante(s) de Quitar el(los) soporte(s) de fábrica del colgante del silenciador: Retirar (2) tuercas hexagonales por soporte colgante para quitar. Devolver los soportes y goma más posterior(es) y el colgante de goma cerca del eje trasero. Rociar un fijadores al propietario del vehículo.
  • Página 23 Retirar el(los) protector(es) térmico(s): Retirar las tuercas hexagonales (3 a 5 Instalar los fijadores de unión posteriores: Usando los alambres de halar de 3/8 que se suministran, insertar los pernos de carruaje de 3/8-16 x 1-1/4" de largo por protector térmico) que sujetan el(los) protector(es) térmico(s) a la parte inferior y las arandelas especiales (pieza 3) a través de los orificios de 7/8"...
  • Página 24 10. Levantar el enganche a su posición:- Instalar arandelas cónicas dentadas de 11. Apretar todos los fijadores de 3/8-16 GR5 con una llave de torsión a 3/8 y tuercas hexagonales en las uniones delanteras de pernos de carruaje. 30 Lb.-pies (41 N*M) Instalar bloques espaciadores (pieza 7), arandelas cónicas dentadas de 3/8 y Se necesita la torsión adecuada para mantener el enganche unido tuercas hexagonales de 3/8 en las uniones de pernos de carruaje más posteriores...

Este manual también es adecuado para:

77327

Tabla de contenido