Cequent Performance Products 24934 Instrucciones De Instalación página 6

5. Reach in behind the side marker light area and find tabs to release cleats
that hold the wheel arc in place, carefully pull the wheel arc away from the
vehicle while using the plastic pry tool to release the cleats. Near the top,
locate the white plastic retainer fastener and remove it using the pry tool.
Repeat for each side.
7. Remove the 8mm screw from under the rear hatch securing the bumper
fascia. Repeat for each side.
©2015 Cequent™ Performance Products, Inc. -
Printed in Mexico
6. Locate and remove the 8mm screw behind the wheel arc that holds the
fascia to the vehicle. Repeat for each side.
8. Remove the (2) 10mm plastic nuts from the fascia brace on the underside of
the vehicle above the muffler. (Lowering the exhaust by removing the rubber
isolators may ease the removal of these fasteners). Repeat for each side.
Sheet 6 of 24 24934NP 7-15-15 Rev. A