Cequent Performance Products 24934 Instrucciones De Instalación página 8

13. Reuse the 15mm flange nuts on the (6) frame studs to secure the hitch and
the bumper.
15. Measure to find the center of the fascia, mark the area to be trimmed 1 ½"
from the center to left and right of center for a total of 3", upwards 5" from
the bottom edge of the fascia for a rectangle shape of 3" x 5" located at the
bottom, center edge of the fascia. Carefully trim fascia.
©2015 Cequent™ Performance Products, Inc. -
Printed in Mexico
14. Tighten the 15mm flange nuts to 38Lb.-Ft. (52N*M
Proper torque is needed to keep the hitch secure to the vehicle
when towing.
16. Reinstall the bumper cover by following the disassembly steps 1-10 in reverse
order. Replace the removed plastic rivets (step 3) with those supplied in the
hardware kit. Attach using a plastic rivet gun.
Sheet 8 of 24 24934NP 7-15-15 Rev. A