Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
⑤
B. Align block on
A. Insert bolt and
access hole
Block into frame
Figure 3
1.
Remove bumper fascia – use 7 mm socket and T15 driver to remove (4) screws at bottom center of fascia, (6) screws beneath splash board and on the side of heat shield (each side), and (3) screws inside
wheel well (each side). Open the trunk and gently pull the fascia away from the car. Disconnect electrical connector on the driver side before completing fascia removal.
2.
Use 15mm socket to remove (2) flange nuts on each side of rear exhaust hanger bracket and take off the bracket. Then remove (3) places rubber exhaust hangers separately.
3.
Use flat head screwdriver to remove (10) nuts attached on heat shield. Trim the heat shield as shown in Figure 2 and to be reinstalled after trimming.
4.
Raise hitch into position and align forward mounting hole with hole on the frame. Using hitch as a template, mark and drill a rear mounting hole (17/32'') on both sides of the frame. Make sure the hitch is
secure before drilling.
5.
Feed the carriage bolt ① and spacer ② through slots on bottom of frame rails using the pull wires ⑤, as shown in Figure 3. Leave pull wires attached.
6.
Raise hitch into position again and feed the pull wires previously installed through holes on the bracket. Remove pull wires and loosely install conical washer ③ and hex nut ④ to the hitch.
7.
Tighten all ½'' GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
8.
Reinstall exhaust hangers, exhaust hanger brackets, fascia, and all fasteners removed in Step 1, 2.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 24927, 60365, 77314,
(Sold separately)
Drawbar Kit:
Drawbar must be used in the
RISE position only.
Fastener Kit: 24927F
Drill
Hole
C. Pull bolt
thru block
Figure 1
Rear
CQT24927
3593
①
②
Frame rail
Drill
Hole
③
④
Sheet 3 of 15
①
Qty. (4)
Carriage bolt
½-13 x 1.75 GR5
②
Qty. (4)
Spacer
.250 x 1 x3
③
Qty. (4)
Conical washer
½''
④
Qty. (4)
Hex Nut
½ -13 GR2
⑤
Qty. (4)
Pull wire
½-13
Figure 2
6''
5''
2.5''
4''
24927NP
06-08-16
6''
5''
Rev. D
Publicidad
Tabla de contenido
