Cequent Performance Products 24921 Instrucciones De Instalación

Frame rails
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 24921F
Wrenches: 17mm, 19mm
Note: Fasteners typical
both sides
j
Qty. (4) Bolt M12 X 1.25 X 35 CL8.8
If present, remove the tie down brackets from vehicle frame rail. Return bolts and tie down bracket to owner.
1. Raise hitch into position and install fasteners as shown above.
2. Tighten all fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
© 2014, 2015 Cequent Performance Products, Inc
Installation Instructions
Scion tC
Fascia
(Sold separately)
Drawbar Kit:
3592
Drawbar must be used in the
RISE position only.
Existing weldnuts
k
j
k
Qty. (4)
Sheet 1 of 3
Printed in Mexico
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Wiring Access Location: PC3, 4
Frame rails
k
j
Conical washer ½"
24921N 10-05-15
Part Numbers:
24921
60351
77308
24478 UH
Rev. B
Form F206 Rev B 9-17-2012