Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
1) Unpack humidifier from carton.
2) Remove all packaging materials, wick, etc. from box.
Base
Wick
Manual (not shown)
WATER FILL AND WICK REPLACEMENT
CAUTION: Before filling, ensure unit is turned OFF and unplugged.
NOTE: Unit will continue running, even when out of water.
1)
Lift chassis (top section) off base. Position wick in the notch at the back of
the base.
2)
Before replacing the chassis, fill the base with unsoftened water. DO NOT POUR
WATER OVER THE ELECTRICAL CHASSIS. Fill the base (see illustration, next
page) to the level marked "MAX FILL" on the center bottom of the base.
3)
If water spills on the chassis, it must be allowed to dry completely
before turning on the humidifier. If you have only softened water
available in your home, you can use it, but you will notice a build up of
minerals on the evaporative wick much sooner. Base capacity is 1.2
gallons. DO NOT OVERFILL.
*Parts and accessories may be ordered by calling 1-800-547-3888, or visit
www.essickair.com or www.AIRCAREproducts.com. Please have model
number of humidifier available when ordering.
CHASSIS
ANALOG
HYGROMETER
BASE
Replacement Parts Available For Purchase*
Description
HUMIDITY
CONTROL
KNOB
FAN
SPEED
KNOB
1040 WICK
Part Number
1B71891
SGL1040
1B72897
4
Publicidad
Tabla de contenido
